When it is time for Genie garage door opener remote program project, you can always depend on yourself to do it alone. All you need to prepare are the ladder to reach the opener and remote control you want to learn to the opener. The basic programming for Genie garage door opener is by pressing, holding and releasing the button on the opener and the remote, just within minutes the remote control can operate the door.
Genie garage door opener remote program project for IntelliG Series openers applies the same way as any other remote programming. You need to reach the opener head and locate the PROGRAM button along with the two indicator LEDs. Press and hold the square PROGRAM button on the opener head, do not release it until you see round small indicator LED is on. The long red indicator LED is blinking, now you can start to program the remote. Within 30 seconds or as long as the long LED is blinking, try to hold the remote button you want to program to the opener in a distance of 4 or 5 feet away from the opener. Press and hold the button and then release it, repeat the pressing and holding and then releasing the button on the remote for 3 or 4 or 5 or until the door operates. When the door activates, you have successfully programmed the remote.
Genie garage door opener remote program project for IntelliG Series that manufactured from 2009 until July 8, 2011 starts by pressing and holding the PROGRAM button until the round small blue LED light is on. After that, you can release the PROGRAM button on the opener. Press again the PROGRAM button and do not release it until long red LED light is illuminating. When you release the button, the long red LED is blinking. You need to press the remote that have already programmed for one time just to unlock the programming feature. At a distance of 4 or 5 feet away, press the button 3 or 4 or 5 times until the door activates.