Programming Garage Door Opener Genie G3T-BX Remote

July 26, 2014 | By Rahma | Filed in: Door Opener Accessories.

Genie always makes sure that any of Do-It-Yourself products are easy to install, adjust and program. Programming any Genie garage door opener accessories is always easy and simple, the easy and simple programming is also applied when you want to program the Genie Intellicode remote. It is important to know that before the programming garage door opener Genie G3T-BX remote, you can change one button of the three buttons from the Intellicode 2 setting to be Intellicode 1. You can follow the instructions below:

To start the setting, first of all please select the chosen button you have programmed. Press the chosen button for about 10 seconds, the LEDs of Green and Red are on and stay lit. Press the chosen button again for two times, the action is meant to change the Intellicode selection from Intellicode 2 to be Intellicode 1. To confirm the changes, press the chosen button once. The LED is blinking red and it means the Intellicode selection is changed to Intellicode 1. Programming garage door opener Genie G3T-BX remote can start now.

To start the remote programming, you need to locate the learn code button and radio signal indicator light LED on the power head receiver of Genie garage door opener. You might need a ladder to reach the motor head on ceiling to find the black learn code button behind the light lens and near the antenna.

The programming garage door opener Genie G3T-BX remote begins with pressing the learn code button on the power head, the radio signal indicator will blink for about 30 seconds. Within 30 seconds, press the button of the remote. Press again the remote button to store the signal in the receiver. You need to be at least two feet away from the power head during the programming process. To test the system, press the button on the remote and the door should move now.

Chose the button that you want to program with the receiver on the opener and stick with the button until the end of programming process

Choose the button that you want to program with the receiver on the opener and stick with the button until the end of programming process.


Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *