Genie garage door opener for DIY market is easy to install and assemble. When you perform an installation project of Genie garage door opener you need to read carefully the owner’s manual that comes with the opener. Genie makes sure that any installation project is easy and simple to do, Genie garage door opener parts are packaged in some boxes to ease the process of assembling.
The first thing to do when in opener installation is assembling the rail. Make sure before opening packages of boxes you have a spacious, clean and flat surface of a room. Your workspace should big enough to place the rail and any contents for assembling. Since some openers have same Genie garage door opener parts, so there will be fewer boxes arrived. When you received a package of garage door opener from Genie, you will get 4 boxes inside the carton marked with 1-4 number. Remove the boxes labeled 1-3 carefully. Each box contains assembly parts and contents, both parts and contents are categorized by assembly tasks. For box with label number 4, you can place it in a safe place for later use.
For Chain Drive rail assembly, first thing to do is removing two rail sections on the floor. Take the third rail section with the chain and the plastic sleeve. Put it on the floor and expand the chain out, it should be 7 feet in length. Take out the wire ties and plastic bags from the chain. Pull the chain straight and wrap the chain around the chain-tensioner pulley to make straight the three rail-sections. Fasten the two rail clamps to rail section joints with four bolts and nuts. If you have assembled the clamps and rail sections, fasten the bolts and nuts tightly. The Genie garage door opener parts quick reference for assembling is equipped inside the lid of each box to ease the user assembling the parts and components.