Programming Genie Garage Door Opener for ISD1000 Model

The Alliance Manufacturing, later called Genie, in 1954, firstly introduced a garage door opener. The manufacturer designed this wireless device to do remotely open and close garage door with a click away without any portable device needed. As the largest garage door opener manufacturer, Genie has produced various kinds of garage door openers and its accessories such as remote control, wall console, wireless keypad, etc. and such devices are easy to be programmed. For example, programming genie garage door opener ISD1000 model, you just need a few minutes to do the instructions as written below.

Programming Genie Garage Door Opener

Programming ISD1000 with the digital wireless keypad is simple

Programming genie garage door opener such as ISD1000 with the digital wireless keypad is very simple. First, you have to reset the keypad to factory setting. You may start with opening halfway the keypad cover and press and hold “8” button as you can completely open the keypad cover. If it is successful, the indicator light will flash once and goes out. The reset is finished as you close the keypad cover and now programming genie garage door opener ISD1000 model with wireless keypad is now ready.

Once again, open fully the keypad cover, at this time the indicator light blinks one time. In order, press the 3, 5, 7 buttons and end it by pressing the PROG button. You will see an indicator light will blink once every second. You may enter your PIN and end it by pressing the PROG button. You will see at this time the indicator light blink twice every second as it is finished and you may close the keypad cover.

Get the Learn Code button and press it, you will see the LED light flashing. Once again, repeat the instructions, fully open the keypad cover and enter the PIN. To end it just press the SEND button and release it as the door fully operates.

hit tracker