Genie Garage Door Opener Repair

Genie Garage Door Opener Repair: Fixing the Circuit Board

To have a genie garage door opener at our home must be something excited. This helpful device will be useful enough to get us to stay dry while the garage door are opening or closing by itself on a rainy day. Nowadays to have a genie garage door opener is no longer need, but a must have device. But, there is still time when your genie garage door doesn’t work as it’s supposed to. Instead of replacement, you need to consider doing genie garage door opener repair first.

When you get stuck with your garage door because it won’t close or open at all, you may get problem with your circuit board in your garage door opener. It may be broken so it went stuck in motion. Get your tools and start doing genie garage door opener repair.

First, you need to get the part of your garage door opener control holder from ceiling. Put it in a safe place. Unscrew the retaining screws and take away the circuit board, start to examine is there any cracks. Thoroughly apply epoxy liquid to hold the broken parts together. Let it dry for more or less an hour.

Second, you need to remove every single of debris left from the crack by scraping it using utility knife. Seal back the cracking are using solder over it, use flux liquid to the previous cracking area and on the circuit board bearing copper joints too.

Genie Garage Door Opener Repair
Check whether or not it has a broken part

Remove the excess of flux liquid circuit board by applying alcohol. Rub the alcohol over the dirt of the excess liquid. Next, make a hole at the edge of the cracking area using small drill bit hand drill in order to stop any more cracks across circuit board.

Put the circuit board back into your garage door opener mechanism and reinstall it. Check whether it is working properly or not by doing a test and your genie garage door opener repair is finished.

Incoming search terms:

genie circuit board problems

Leave a Reply

Name *
Email *
Website