Genie Door Opener Keyless Entry Code Pad

August 20, 2014 | By Rahma | Filed in: Installation Tips.

There are several ways to access and control Genie garage door opener, Genie door opener keyless entry code pad is one of the device to access and control the door opener. To make the keyless entry code pad function well, you need to follow several steps in the programming instruction or owner’s manual that comes with the pad or the opener.

Genie door opener keyless entry code pad is one of the device to access and control the door opener

Genie door opener keyless entry code pad is one of the device to access and control the door opener

If it is your first time to program Genie door opener keyless entry code pad, it is better to follow below instruction. The instruction below is the instruction to program one garage door opener only.

The first step is locating the PROGRAM set key button or learn code button on the opener motor head. The PROGRAM set key button is typically located on the bottom of the cover of the opener, while the learn code button is located under light bulb lens cover or under the cover of the opener motor.

The instruction below is the instruction to program one garage door opener only

The instruction below is the instruction to program one garage door opener only

After you find the PROGRAM Set key button, press and hold down the PROGRAM set key button for about two seconds. Near the key button, you will two indicator light LEDs, one is small and round LED while the other is long LED. After the PROGRAM Set key button is released, the small round LED turns blue and off at the same time the long LED is flashing purple. For opener with the Learn code button, press and release the learn code button, you will see the indicator LED starts blinking.

The first step of programming keyless entry code pad is locating the PROGRAM set key button or learn code button on the opener motor head

The first step of programming keyless entry code pad is locating the PROGRAM set key button or learn code button on the opener motor head

Now, before the LED stops flashing or blinking enter the PIN on the keyless entry pad and press the down/up arrow key button for once. Both of the LEDs stay lit. Press the down/up arrow key button again, both of the LEDs are off. Push the down/up arrow key again for the third time, it will make the Genie door opener starts to operate to go down or go up. Make sure you there is nothing on the door pathway.


Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *