Genie Excelerator Manual: Resetting Remote Access

August 28, 2014 | By Rahma | Filed in: Installation Tips.

Genie Excelerator is one of the Genie garage door opener models that uses screw-drive system. The Genie Excelerator is claimed as the fastest garage door opener made by Genie since has used powerful DC motor. The opener is also a quiet opener though does not use a belt, but a sturdy polymer rail liner which works to reduce metal to metal contact. The result is a fast and quiet opener. Genie Excelerator uses remote as the access entry device to control the garage. It will be easier for anyone in your home to control the opener in a single click of a remote button. If you lost your remote control or your remote is stolen, better to save the additional remotes by resetting the remote access according the Genie Excelerator manual instruction.

Genie Excelerator is claimed as the fastest garage door opener made by Genie since has used powerful DC motor

Genie Excelerator is claimed as the fastest garage door opener made by Genie since has used powerful DC motor

The action is a preparation when unwanted people have the stolen/lost remote and use it unwisely to breach the garage. Resetting the remote for Genie Excelerator is as simple and easy as the other Genie remote with rolling code technology. You can always refer to the Genie Excelerator manual instruction to do the resetting project or watch the programming instruction on Genie website.

Genie Excelerator uses remote as the access entry device to control the garage.

Genie Excelerator uses remote as the access entry device to control the garage.

To reset the Genie Excelerator remote access you need an access to your Excelerator opener. Open the rear back of the motor unit, find a terminal block. Between the terminal block and force adjustment screw, you will find the Learn button. Press and hold down the learn button, the LED light located under the learn button will glow. Do not release the button until you see the glowing LED light is off. It indicates that all the codes stored in the memory are erased and you can begin the resetting project as Genie Excelerator manual instruction told you. Hit the learn button, LED light is blinking. Press and release the remote button you want to program to the opener, LED light stays lit. Press and release the remote button again, the LED light goes off. Repeat the instruction for any additional remotes you have.

. Resetting the remote for Genie Excelerator is as simple and easy as the other Genie remote with rolling code technology

. Resetting the remote for Genie Excelerator is as simple and easy as the other Genie remote with rolling code technology


Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *