Genie has made their devices not only easily to be programmed to Genie system but also other system such as HomeLink. As another Genie garage door openers programming instruction, a step by step below of HomeLink In-Car Remote programming is also simple and takes a few minutes.
Genie garage door openers programming Homelink In-Car remote programming is an attempt of programming a built-in-car transmitter to Genie Intellicode system, the rolling code garage door opener system. The system is a security system that able to choose billions of code differently every time the door is close or open.
First step in Genie garage door openers programming, you need to remove all programs from in-car system previously made by factory. Please hold the two outside buttons together and do not release before you see the in-car LED is blinking fast. You need to wait for about 60 seconds (generally, the key is on auxiliary and or the door is shut)
Next, you have to make a decision which button that will be your in-car garage door transmitter. Put your transmitter near the selected button, hold transmitter up, and simultaneously press both the button on the remote and selected in-car transmitter button. Do not release both the buttons until you see the in-car, LED light is blinking fast. Now, the in-car remote transmitter is set to your garage door openers make transmitter.
Continue the process of in-car transmitter to be your private transmitter. You need to locate Learn Button on the rear panel main motor head unit. Press the learn button and the indicator light is on and blink but stays lit. Get back to your in-car transmitter, and press the previously in-car transmitter button for three or four times or until you see the door is moving. Once your garage door opener is moving, your in-car is now successfully programmed to open garage door opener.