Operating Genie Garage Door Opener Remotes

June 19, 2014 | By Rahma | Filed in: Door Opener Accessories.

Genie garage door opener is a known garage door opener manufacturer since 1923. The company successfully maintains the products to be reliable and powerful. Genie garage door opener devices are included Genie garage door opener remotes. In one single click of button, your garage door opener will automatically open or close while you conveniently sit behind the wheel.

Genie Garage Door Opener Remotes

You need to operate your remote properly to get the opener works as it should be

Mostly Genie garage door opener is equipped with standard security system that allows the access code is changed every time the door opener is engaged. As the remote controller security codes can be changed at any time, it is important that you pay attention to your Genie garage door opener remotes operation.

To operate Genie garage door opener remotes properly is simple. Get your remote controller points at the garage door and just click the remote control button. You will see the door is moving and as you click the button once more while it is moving, the door will stop moving. Pressing the button again will cause the door reverse the motion. When it reaches end of open or close cycle, your door will stop automatically. At the point of maximum range, you need to point the remote to the door and click the remote controller button.

Some of Genie remote controllers are equipped with visor clip. To attach the visor clip you need to spread the wire ends each into two holes in both sides of your remote rear side. You can inserted the clip up or down side.

When you find that your remote control cannot open the garage door, it is better to check the battery. This battery powered remote control will not properly work as the batteries are low, to replace the battery you need to remove the battery cover first. Slide the cover down by pressing the cover with below arrow on it. Get the old batteries out and place the new batteries on the same side of the old batteries position. Put the cover back on its previous place.

Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *