Programming Garage Door Opener Genie Pro Max Remote Controls

Programming garage door opener Genie Pro Max remote controls for one-button or multi button remote controls are as easy as the other programming remote control on Genie’s models. Before performing the programming, you need to be cautious of your safety and the safety of your surroundings. The factory has designed the remote control codes are set differently at the factory and you need at least to be as far as 24 inches from the antenna during programming.

programming garage door opener genie

The factory has designed the remote control codes are set differently at the factory

In programming garage door opener Genie Pro Max remote controls for one button, first you need to locate the learn indicator light and learn code button on the power head. You can find the button by removing the cover lens on the rear side of the power head. As you find the button, you can press and release the learn code button and you will see the LED indicator will flash twice per seconds. Get your remote, press the remote control button and release it quickly. The LED is off. Press again the button on your remote and release it fast, LED indicator is off as it means that the remote is finally programmed.

For multi-button remote, programming garage door opener Genie Pro Max can be done by repeating the step from press and release the learn code button. You have to program the button one by one as each button on the multi-button remote control is designed for a different operator.

Try to take a test by operating the remote control, you can point the remote at the door. You should see the door is moving. Try to stop the movement of the door by pressing the same button again. If you press the same button on your remote control again, it will cause the door moving in the opposite direction from the previous direction before the door stopped.

hit tracker