Programming garage door opener remote Genie Reliag 800 is acquired no special skill nor a professional assistance included. You can easily program the remote control of Reliag 800 by following the clear instruction in the owner’s manual.
You will have one-button or multi-button remote control depends on the model that you have. Anyhow, both one-button and multi-button garage door opener remote Genie Reliag 800 still easy and simple to be programmed.
For one-button remote control or multi-button remote the first thing to do is look for the learn code button and the indicator LED located on the power head of the opener. Next, press and release the learn code button on the power head and you will see the indicator LED responses by blinking in red for two times per second. Go get your remote control and push the button on the remote control that you want to program for one time within 30 seconds after the LED is blinking. The indicator LED will respond by stop blinking and stay lit solid. Push the previous button on the remote control to end the program and the LED indicator will go off. Your remote is ready to control the door, you can test it by push the button you have previously programmed and your door will automatically move.
For multi-button remote control, you need to program each button separately by performing the one-button remote control steps instruction above. You cannot program all buttons on the remote to control the same door. It also applies the other way you cannot use one button on multi-button remote to control 2 doors. In a single programming, you can store up to seven transmitter, remote control, or any other wireless devices.
If you want to erase all the memory as your garage door opener remote Genie Reliag 800 is stolen or lost, just press and hold the learn code button on the power head until you see the indicator LED is blinking red and goes out or wait for 10 seconds. The memory is now erased and you can program the new remote by performing single or one button remote control above.