How To Program A Genie Garage Door Opener Keypad Procedure

Genie garage door opener keypad is one of Genie access entry devices. Keypad can control the garage door to open and close as well as the remote controller. Genie access entry devices are now equipped with sophisticated security system called Genie Intellicode. Genie GK-R Intellicode2 Wireless Keypad is one of the access entry devices that use the Intellicode technology.  As well as the remote control how to program a Genie garage door opener keypad including the Genie Intellicode keypad is relatively easy.

As long as you find the learn code button, how to program a genie garage door opener keypad is always simple. Once you locate the learn code button on the power head, follow these procedures:

Press and hold the PROGRAM button on your keypad for about two seconds. The small round indicator LED turns blue and then go off, while long oval indicator LED flashing in purple.

Go to the opener and press learn code button. Indicator LED on the opener will start to blink.

Enter your PIN that a combination up to eight digits of numbers and press the up or down arrow key. The indicator LED on the opener will stay lit.

Press the down or up arrow key again to store the memory and the indicator LED of the opener is off.

Press again the down or up arrow key will move the door.

GK-R Intellicode2 Wireless Keypad uses Genie Intellicode 2 technology but you can change it into Genie Intellicode 1 technology by following the how to program a Genie garage door opener keypad for changing Intellicode 2 to 1as follows:

Press and hold the PROGRAM button and up or down arrow key button simultaneously for about 5 seconds. Press the number 3-5-7 buttons in order and press PROGRAM to end it. Enter the PIN and press PROGRAM button. The next step you have to completely close the keypad cover and wait for 30 seconds.

Open the keypad cover fully and enter your PIN. Press the up or down arrow key button and end it by pressing and holding the PROGRAM button. Do not release until you see indicator light is turning red and close the keypad cover. Repeat the above instruction for programming keypad to synchronize it with opener.

How To Program A Genie Garage Door Opener Keypad Procedure

It is better to perform how to program Genie garage door opener keypad instruction before mounting the keypad.

hit tracker