Manual For Genie Garage Door Opener Powermax 1500 Programming

Genie Powermax 1500 is equipped with a manual to help the users to install, program, adjust and troubleshoot without professional assistance. Manual for Genie garage door opener contain helpful instructions and one of them is the programming for remote and keypad.

Let’s start with programming manual for Genie garage door opener Powermax 1500 remote control. For Powermax 1500 you can program remote to New Intellicode 2 openers. This programming instruction is applied for all type remotes. As any other programming instruction, you need to locate the program button and the program indicator light on the power head. If you have multi-button remote, you need to program the button individually using below steps:

At first, push and hold the PROGRAM button on the power head for about two seconds or do not release it until small round LED on the power head turns blue. When you release the button the long LED is flashing purple. Next step, get your remote device and choose the button you want to program. Press and release the chosen button. The long LED stays lit in purple and then both of LEDs will go off. Next, press and release the chosen button again, and this time the door will move. The program for remote button is done.

The keypad programming manual for Genie garage door opener Powermax 1500 is applied for both Intellicode 1 and 2 wireless keypad. Just like the remote programming, you need to locate the program button and LED indication. The programming starts with entering PIN on your wireless keypad and then you need to go to power head to reach the program button. Press and hold program button for about two seconds or do not release until you see the small round LED is turning blue and the long LED is flashing purple. Next step, press and release the up/down arrow button twice, both LEDs indication aree off. Press and release the down/up arrow button and now the door is moving.

manual for genie garage door opener

Any accessories programming start by locating the learn button or program button.

hit tracker