How To Program My Genie Garage Door Opener Intellicode Keypad?

July 13, 2014 | By Rahma | Filed in: Door Opener Accessories, Installation Tips.

Do you have a Genie Intellicode garage door opener that cannot operate through remote control? Have you tried any attempts to make the remote works? If the answer is yes, but the remote still cannot control your Genie Intellicode garage door opener, it is time to get a Genie garage door opener remote replacement. You may want to consider Genie GK-BX Intellicode Wireless Garage Keypad. The keypad will work on 390MHZ frequency and you will not need any keys or remote any more to open your garage door. This keypad is compatible to use with all Genie Intellicode 1 and Intellicode 2 system.

how to program my genie garage door opener

When your garage door opener controller acts up, its time to buy the replacement and program it.

How to program my Genie garage door opener Intellicode keypad? To program your new Genie GK-BX Intellicode wireless garage keypad is relatively easy just like any other keypad programming. At the factory the keypad is already programmed, you can erase all of factory program settings by pressing and holding PROGRAM key button and up/down arrow button simultaneously. Do not release the buttons until you see the light flashes from the keypad for two times and suddenly go off.

How to program my Genie garage door opener new keypad for Intellicode 1 is starting with opening the cover keypad in a completely full open position, press the number 3-5-7 buttons in sequence. Press the PROGRAM key button to end it. Enter the secret PIN and end it by pressing PROGRAM key button. Close the cover keypad and proceeds the process after 30 seconds.

Open the cover keypad in full open position and enter the secret PIN, after that you can press the up/down arrow button and release it. The light on the keypad will flash and stop flashing. Press and hold the PROGRAM key button, you can hold until you see the light on the keypad changes from green to red and release the button. This how to program my Genie garage door opener Intellicode keypad is finished and you need to synchronize the keypad to opener. Go to the opener and press and release the learn code button, get your keypad and enter your PIN along with pressing down/up arrow button for about 3-5 times until you see the door is moving. After the backlight is off or 30 seconds after it, enter the PIN and press the up/down arrow button again the door activates.

Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *