Installing Genie Garage Door Opener Excelerator

Genie Excelerator is one of the fastest Genie garage door openers. Genie Excelerator is one of the DIY products of garage door opener that need to be installed. All of Genie garage door opener products are equipped with a clear manual instruction of how to install, assemble, and program. As the Excelerator is one of Genie Do-It-Yourself garage door opener, installing Genie garage door opener parts will hardly difficult to be done.

One of the processes of installing Genie garage door opener Excelerator is to install and connect limit switches. Limit switches are Genie garage door opener parts that allow the door to open and close properly according to the set up. Find parts for installing the limit switches on green parts bag. You will find white wire to connect open limit switch, brown wire to connect close limit switch, arrows point toward door, wire clip and #8-32 x 1″ Hex Head Screws.

To begin installing Genie garage door opener Excelerator, you need a spacious room that large enough for you to move the assembled rail and the head opener. The installation begins with turning the head of the opener, make sure the right side of the opener in up position. Support the power head with something soft, in order avoiding any damage happened to the Light Bulb Sockets. Get the white and the brown limit switch wires and uncoil them. Retain any twist ties. Put the switches on rail, the arrows point towards the door and away from power head. From rail strap, place the brown wire for close limit switch 15” in right position. Keep the wire hold by inserting (#8-32 x 1″) Hex Head Screw into switch hole. Tighten the screw until later. Do it the same way to the white wire. Place the open limit switch white wire 15” from power head and insert another screw to keep it hold, finger-tightened it.

installing genie garage door opener

One of the processes of installing Genie garage door opener Excelerator is to install and connect limit switches.

hit tracker