Garage Door Opener Genie Remote: Genie Master Remote Programming

Do you have a problem with your garage door opener Genie remote? Have done any project remote repairing but your remote still does not work? Perhaps it is the right time for Genie remote replacement. If you do not know what kind of remote that will fit for your opener and do not want to bother looking for remote replacement that compatible with the remote, you will prefer a Genie master remote.

The master remote is compatible with Genie Intellicode 1 and 2 and for Genie openers with 9 and 12 switches too. You will hardly find any difficulties with programming garage door opener Genie remote for this type of remote.

For garage door opener Genie remote that will be used with Intellicode 1 openers ,you can start programming by locating the learn code button and learn indicator LED on the power head on your openers, once you find it proceed with these steps: press and release learn code button. Learn indicator LED on the power head is blinking. Press and release a chosen remote button. Learn indicator LED stop blinking and stays lit. Press and release the chosen remote button again. Learn indicator LED is off. Press and release the chosen remote button again. The door will activate.

For Intellicode 2 openers, you need to switch the button on your remote to Intellicode 2 operating mode. It is marked with a Green LED on the remote when you press it. Start to switch the remote to Intellicode 2 mode, press and hold the button on the remote you want to program. The LED indicator will stay red and after 10 seconds, the other LED will be flashing green too. You can release the button. Next step, press and release the chosen button two times, both LEDs will turn off. Press and release the same button the Green LED remote is illuminated, the remote is in Intellicode 2 mode now.

garage door opener genie remote

The master remote is compatible with Genie Intellicode 1 and 2 and for Genie openers with 9 and 12 switches toorremote.

Continue the process to program the remote with opener, press and hold the PROGRAM button on the opener until the round small LED flashing blue. Release the button, blue LED is off while long LED is flashing purple. Press and release the remote button so the signal can be stored. Press and release the button again, both LEDs are off. Press and release the remote button again, the door is moving.

hit tracker